Written by Chris Goodell, P.E., D. WRE | WEST Consultants
Copyright © RASModel.com. 2009. All rights reserved.
One of the first steps (usually in the proposal stage) of a dam breach model is to visualize where the flood wave will travel downstream from the dam. Is there a very obvious main channel entrenched in a canyon (if so, you have a fairly easy task). Many times, dam breach models are not this straight-forward. I have this dam breach project I'm getting ready to start. Just below the dam, two tributaries (fairly canyonized) converge with the primary stream. This spot is wide open and flat. My dilemma is how do I set up my model just below the dam. Water will come out of this breach and go up both tribs and probably swirl around quite a bit just downstream of the dam before eventually heading down the primary stream. Originally I thought about coupling a 2-D model with RAS, but that can be a real pain (not to mention possibly blow the budget). I'm now thinking of setting up the downstream area as a Storage Area in RAS with both secondary tribs included as part of that storage area. Then I'll connect the primary reach to the storage area so that the dam breach flood wave can drain downstream. I've placed inline storage areas further downstream in dam breach models, but never just below the dam. Hope it works. I would love to hear any comments or suggestions...
Copyright © RASModel.com. 2009. All rights reserved.
One of the first steps (usually in the proposal stage) of a dam breach model is to visualize where the flood wave will travel downstream from the dam. Is there a very obvious main channel entrenched in a canyon (if so, you have a fairly easy task). Many times, dam breach models are not this straight-forward. I have this dam breach project I'm getting ready to start. Just below the dam, two tributaries (fairly canyonized) converge with the primary stream. This spot is wide open and flat. My dilemma is how do I set up my model just below the dam. Water will come out of this breach and go up both tribs and probably swirl around quite a bit just downstream of the dam before eventually heading down the primary stream. Originally I thought about coupling a 2-D model with RAS, but that can be a real pain (not to mention possibly blow the budget). I'm now thinking of setting up the downstream area as a Storage Area in RAS with both secondary tribs included as part of that storage area. Then I'll connect the primary reach to the storage area so that the dam breach flood wave can drain downstream. I've placed inline storage areas further downstream in dam breach models, but never just below the dam. Hope it works. I would love to hear any comments or suggestions...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.